Please ensure there are no hot or live electrical surfaces!

Step 1: Turn off or disconnect the electrical power to the recess can fixture.

Step 2: Confirm the Product’s input voltage matches or is compatible with the line voltage.
Check the voltage rating on the Product Bar Code label.
Picture Barcode

enLux Lighting is not responsible or liable for incorrect power connection.

The Product only accepts 1Ф (single phase) electricity.

Step 3: Assemble trim and torsion spring bracket to the LED module.

• The screws have NYLOK anti-loosening coating.
• A smaller handle screwdriver may not have sufficient torque to tighten the screws
• The trim screws must be tightened firmly to insure good thermal contact
• Do not over torque the screw to prevent striping the threads.

For DL1-TC5, Fit 5” Recess Can

Picture Step 2

This drawing shows DL1-TC6 and DL1-TC8, Fit 6” Recess Can

Picture Step 3

Step 4: Disassemble the socket bracket from the recess can fixture

Picture Step 4

Step 5: Remove the E26/E27 socket from the bracket.

Picture Step 5

Step 6: Snap and secure both torsion springs to the torsion spring retainers located on the inside wall of the recess can.

Picture Step 6

Step 7: Push the down light up to against the ceiling.

Step 8: The Product is installed and is ready to be operated.