 |
6 K Outdoor Area Light Light Source: Enlux patented COB light engine |
 |
Photometric 1 Photometric 2 |
 |
 |
 |
enLux Lighting has developed the 6K Series LED OutdoorArea Light perfect for all kinds of outdoor lighting applications. From parks to walkways, parking lots to security lighting, the enLux OutdoorArea Light will brighten the great outdoors with a powerful, longlasting light. The enLux patented COB (Chip-On-Board) light engines enable efficient light emitting and heat dissipation, therefore insures 50,000 hours life.
The enLux 6K Series LED OutdoorArea Light is available in 3000 lumen and 6000 lumen output, three White CCT (2700K, 3500K, 4500K), 4 standard colors (red, green, blue & amber) and several custom colors. It is available for use in 100V, 110V, 120V, 220V, 240V, and 277V input.
The standard stock item is the Model 694203, which employs (8) enLux patented COB light engines, a CCT of 4500K, 3000 lumen output, 120V input, Clear Anodize. The standard Model 694203 provides an efficient light output of 800 lux (1m) using just 100 watts of power consumption.
Instruction Manual For enLux 6K Series Outdoor Area Light
Important: When using electrical equipment, safety precautions should always be observed.
1. READ and FOLLOW ALL SAFETY INSTRUCTIONS
2. Ensure there are no hot or live electrical surfaces
3. Use a lift for installation; the Product weighs up to 20 lbs.
4. Required tools and materials for the installation (not supplied with the Product):
- 6mm Allen key wrench
- Connectors for electrical wire connection
- Silicone sealant
Installation
Step 1
Turn off or disconnect the electrical power to the light pole.
Step 2
Confirm the Product’s input voltagematches or is compatible with the line voltage. Check both the Product barcode and the voltage tag.
The Product only accepts 1Ф (single phase) electricity.
Caution! enLux Lighting is not responsible or liable for incorrect power connection.
Step 3
Connect the wires accordingly Black/White – Line voltage , Green – Ground
Make sure all wire connections are electrically insulated.
Step 4
Secure the Product to the pole by tightening the 2 mounting screws using the 5mm Allen key wrench
Step 5
Apply the silicone sealant on to the junction between the Product and the pole to ensure weather tight seal.
Step 6
The Product is installed and is ready to be operated.
